Hold down the Casita Canopy using this bundle of 4 Ropes and 4 Metal Stakes. Drive the stakes into semi-soft ground 8 inches or so away from each leg of the casita canopy, with the hook end of the stake facing away from the casita canopy. Loop rope under each hook end of stake and around each leg. Then tie to secure. Rope and stakes come in a nylon bag.

Shipping Dimensions:
4″L x 4″W x 12″H

Equipped with two wheels and a pull handle, this Casita Canopy Bag is fit for a 15ft or 20ft Casita frame. Easily transport your tent to any event. Compact size for a large surprise.

Add extra oomph to any size Casita Canopy by attaching a flag! To attach a flag*, first add this Casita Canopy Flag Connector. Place this Flag Connector at the desired height onto the leg of the frame. Then, simply twist included knobbed screws to tighten. Add the flag and voila!

Please note:
1. *Use with Small Feather Banner Flag ONLY.
2. Open Casita fully and add canopy top, back wall and half-side walls before attaching Flag Connector.
3. This add-on has a toolless assembly
4. Pole Length: 7.75″
5. Hole Diameter: 1″

This black nylon sand bag cover is used to protect your sand bag as well as to easily attach your sand bag to one leg of the Casita Canopy for added weight against wind. Included is the cover and hook. Do not fill this cover with sand. To use, slip hook through the grommet located on the handle of the cover and then close hook around leg of casita canopy. With the cover already on the ground, open velcro opening and place sand bag* inside the cover. Close velcro opening, and you’re done.

Dimensions:
11″L x 11″W x 6″H

*Sand and sand bag are not included with the cover, nor do we sell sand bags or sand.

Equipped with two wheels and a pull handle, this Casita Canopy Bag is fit for a 10ft Casita frame. Easily transport your tent to any event. Compact size for a large surprise.

Size:
Dimensions: 20″W x 20″H x 6″D

Weight:
7 lbs

When adding a custom back wall and/or half-side wall(s), this Rail is a must-have for the 10ft Casita Canopy. To Position, first clamp snap rings around the legs of the frame. Slide Rail through the pole pocket expertly sewn on the top of the back wall and/or half-side walls. Bring Rail with fabric up to clamp snap rings, and tighten ends with knobbed screws. This add-on has a toolless assembly.

1 Rail includes:

• Aluminum Rail (left side, right side & rail connector)
• 2 snap rings

1 Rail for 1 Backwall (bottom)
2 Rails for 1 Sidewall (top & bottom)

Shipping dimensions for 2 sets of Rails
58″ x 5.25″ x 2.5″

Shipping dimensions for 5 Rails
58″ x 6″ x 6″