​

Vail-40D 9’ x 6’ Frame Only. The VAIL-40D is a double-sided extrusion with a profile width of 40mm. The alternative extrusion in style to the ASPEN-40D, the VAIL-40D has a solid outside finish. It is especially great for wall mounting and hanging overhead because it is lightweight, but can be used with feet to stand independently as it is more stable than the VAIL-40S. Use fabric Silicone Edge Graphics (SEG) with this frame. When installing the fabric graphic, the keter can fit 12mm deep and 3mm wide into the keter trough. Not compatible with lights (cannot be backlit.)

Frame Includes:
(1) 4-sided frame(4) VAIL Triangle Corner Connectors, (16) Socket Screws, (1) 3mm Allen Wrench (3) VAIL Split Connectors (1 pre-installed on 1 VAIL-40C), (1) Torx Key (2) VAIL Key Locks (pre-installed), (1) 4mm Allen Wrench ((2) VAIL-40C Support Extrusions

Suggested Uses: Retail Stores, Restaurants, Art Galleries, Grand Openings, Trade Shows, Offices, Showrooms, Backdrop, Photo-ops, Step & Repeat, Partition Wall, Etc.
Hardware Setup: To make one edge of the frame, take two cut VAIL-40D extrusions and, between, add Split Connector; tighten. Repeat this twice. Take one completed 9’ edge and one 6′ edge and slide in Corner Connector; tighten. Repeat this three times. Vertically insert ends of VAIL-40C into top and bottom of the frame; tighten.
Upgrade to Replace: VAIL Toolless Corner Connector and VAIL Toolless Split Connector.
Accessories (sold separately): Wall Mounts, Ceiling Eye Hooks, Steel Base, Whistler Feet, Yeti Feet.

Warranty: Lifetime on frame

Frame Size: 108″W x 72″H x 1.57″D
Shipping Dimensions: (2) boxes 73.25″L x 7.25″W x 6.5″H