Vail-60D 5’ x 9’ Frame Only. The VAIL-60D is a double-sided extrusion with a profile width of 60mm. This extrusion has a solid outside finish. VAIL-60D is best for standing independently since the profile width is just wide enough to provide ultimate stability. This extrusion works great overhead too because the thick profile width really stands out. Use fabric Silicone Edge Graphics (SEG) with this frame. When installing the fabric graphic, the keter can fit 12mm deep and 3mm wide into the keter trough. This extrusion is not compatible with lights (cannot be backlit).
Frame Includes:
- (1) 4-Sided Frame
- (4) VAIL Corner Connectors, (16) Socket Screws, (1) 3mm Allen Wrench
- (2) VAIL Split Connectors (1 pre-installed on 1 VAIL-40C), (1) Torx Key
Suggested Uses: Retail Stores, Restaurants, Art Galleries, Grand Openings, Trade Shows, Offices, Showrooms, Backdrop, Photo-ops, Step & Repeat, Partition Wall, Etc.
Hardware Setup: To make one edge of the frame, take two cut VAIL-60D extrusions and, between, add Split Connector; tighten. Repeat this twice. Take one completed 9’ edge and one 5′ edge and slide in Corner Connector; tighten. Repeat this three times.
Upgrade to Replace: VAIL Toolless Corner Connector and VAIL Toolless Split Connector.
Accessories (sold separately): Wall Mounts, Ceiling Eye Hooks, Steel Base, Whistler Feet, Yeti Feet.
Warranty: Lifetime on frame
Frame Size: 60″W x 108″H x 2.36″D
Shipping Dimensions: (2) boxes 73.25″L x 7.25″W x 6.5″H
